Main cutting edge Auger Bit 1750 – 3000 rpm. FAMAG Germany

One-edged countersink with bored hole and countersinking angle of 90°.

600 – 1000 rpm. e.g. Ø 16 mm 800 rpm in soft wood

Bormax® 2.0 prima with exchangeable pre-drill bit, centre drill bit or guiding pin. Much less feed force needed as well as minimized friction and therefore less heat generation. Reasons: The two main cutting edges are grooved shifted, as well as the toothed linear grooved pre-cutters. A matching centre drill bit and an allen wrench are included in the delivery. Hexagonal shank for a better power transfer

One-piece drill bit (C6,3) with brad point, two main cutting edges, two protruding cutting edges and a hexagonal shank for bit holder (1/4“; C 6,3).
Maximum rotation speed of the cordless screwdriver: recommended 3000 rpm

Premium quality version, extra long, fully ground quality with two main cutting edges and two taper taps. Internally ground special spiral for very good chip removal

Twist drill with long shank and specially ground roof-like tip, which can be regrounded easily. Quality according to DIN 7490 and the valid safety regulations.
800 – 2500 rpm, e.g. Ø 10 mm 2500 rpm in formwork panel.
Made in Germany

“Lewis” pattern with crest of thread, main cutting edge and taper tap, morse cone shank No. 2

1250 – 2500 rpm e.g. Ø 22 mm 1500 rpm in soft wood. Further details in the speed diagram